AMC4 based motion control systems are fitted to orthotic modelling and prosthetics machines. These manufacture precise models using data generated within seconds using a revolutionary computer based synchronised digital scanning system. The models are then used to make a wide range of custom prosthetic and orthotic components.

The data, once generated, is transferred at high speed to a high performance three dimensional carving machine controlled by an AMC4. The machine controller is controlled from a PC via simple to use custom control panels generated using WinAMC.

Contact Us for more information about New Controls and Retrofits

• how easy was it to integrate the controller into the machine



• how easy and fast is it to communicate data defining the model from a PC to the machine controller



• how fast does the machine produce a model



• how precise is the machined component - the more precise it is the less the manual finishing required



• how easy is the machine to operate in any country of the world

• the AMC controller is stable and reliable



• WinAMC is simple to customise, controller custom operator interfaces are simple to generate by non PC programmers in any PC supported language



• Machine productivity is dramatically increased



• Model quality is excellent – typically no manual finishing is required



• The model is accurate to better than 0.01 inches (0.25mm)



• Operators do not require ‘machine tool’ experience to operate the machine