Feedrate override potentiometer, Feed hold to 150% of programmed feed
In addition to the buttons there are a number of LEDs that show the current mode of operation as well as the
actual status of outputs 1 & 2.
The handpad takes its power supply from the motion controller and has a power LED indicating when it is active.
It is connected through a shielded cable to a 'handpad' port on the AMC and uses inputs 3 & 4.
Handpad accessories
The Pendant is encased in a standard toughened plastic enclosure. For a small additional cost we can supply a hook set with
optional magnet to allow ease of locating and storing the handpad. The magnet is very strong and easily supports the weight of
the unit and attached cabling.
The hook is of strong plastic design for hanging from a cross bar or loop of up to 18mm in diameter. The magnet/hook combination
is securely attached with three screws to the back of the handpad and hinges neatly away into the unit maintaining the ease of handling
and good tactile feel of the handpad.
Dimensions
The Pendant Handpad is supplied in a plastic IP65 rated enclosure of the following dimensions:-
Length - 275 mm
Width - 130 mm
Depth - 80 mm
